RC Logger Night Fly Kit for RC Eye 650

This product is intended to be used optionally in combination with the RC EYE 650. The night flying kit makes the RC EYE shine in a bright light. The circuit board enables the direct control of various lighting effects, such as running light, flashing and other warning signals. The board is powered by the LiPo’s balancing connector with the cable and connector provided.

- Control of up to 6 super-light Power-LEDs!
The lightboard has two switchable outputs with active power control; 1 – 3 super-light power LEDs can be connected to each of them. LEDs are included with the kit.

- Control of light effects and displays!
The lightboard has 8 LED-outputs that can be connected either to individual LEDs with the required input resistor or 12 V-LED strips. The LEDs or LED strips can be used as running lights, flashlight or to display operating conditions of the RC EYE. Channel 5-8 or an external PPM signal can be used to switch the respective light patterns. A buzzer is available for acoustic output of warning signals. Silicone cover LED strips are included with the kit.

- Servo connection!
Up to 4 servos (channels 5 – can be connected to the lightboard and are then directly controlled by the main control of the RC EYE.

The following items are included in the delivery:

• Circuit board (QC-06) with JST-XH connector pre-soldered
• 2 x white high power LED
• 2 x green silicone cover LED strip
• Red silicone cover LED strip
• Blue silicone cover LED strip
• Interface cable
• 5 x jumper
• JST-EH connector
• JST-TP connector
• Operating instructions

Source: RC Logger

Advertisment

Subscribe to the post comments feeds or Leave a trackback