EVENT COVERAGE: JR Propo at the 2011 Beijing Model Show

Vibe NEX

Here are close ups of the swash controls which use arms located within the frame and mounted directly to the servos output shaft. Then, there are the frame cut outs from the arms to the linkages and up to the swash.

Looks like the Vibe NEX will be running 140 degree CCPM.

Here are a couple of close pics of the new Triple Axis Gyro System 01 (TAGS01) with the gain adjustments located on the unit.

The rudder servo arm uses a clamp down design.

Speed sensor mounted under the main gear.

Of course, what would this heli be without some metal bling on it at specific areas.

XG8 Transmitter

Doesn’t it look striking similar to the 11X?

[View with PicLens]

Nice FBL head with FBL Pitch Tool.

Driving this heli is the JR Propo Scorpion 4025-740kv Motor.

Close ups of the speed sensor placement.

Nice closeups of the tail gear box.

Here is the battery mount which looks to be using a clip design allowing placement of the battery tray either high or low in the battery area.

Single Axis Gyro System (SAGS01)

Here is a very small, about 5mm thick, single axis gyro which JR Propo calls SAGS01.

[View with PicLens]

Here the canopy is shaped to accommodate the large helical cut main gear.

Nice metal head assembly with 3D or F3C options.

Close up of main gear and tail drive gear with optional magnet hole for use with speed sensor.

Here is the view of what looks to be an all metal motor mount.

The battery area allowing for 2 stacked 6S lipo packs and the battery tray with clip type mounting.

Here is a shot of the tail section and the servo layout on the right side of the heli.

Close up of the ESC with fan mounted under the motor, probably to help dissipate heat.

JR Propo Booth

[View with PicLens]

Source: RC Mania

Advertisment

Subscribe to the post comments feeds or Leave a trackback