AVAILABLE NOW: Public Beta for RealFlight

New G5.5 public beta (5.50.033) is available

Version 5.50.033 is now available as a public beta download.

This version is compatible with 5.50.025 for multiplayer.

Perform the following steps to obtain the update:
1. Start the RealFlight G5 Launcher
2. Click Additional Options, then Technical Support
3. Click Enter Tech Support Code
4. Enter the following code: B#jj29hh55x5yq (If successful, you will see a message saying “You are now registered to use the Public Beta site until the new version is posted to official download site.”)
5. Go back to the main Launcher menu and click Registration/Updates
6. Make sure that in the bottom left corner it says Temporary Public Beta (PS). If not, try reentering the code
7. Click Update to Latest Version; alternatively, click Update to Specific Version, choose 5.50.033 from the list, and click OK.

The LauncherHelper will need to restart partway through this process. Answer “Yes” when it asks if you want to continue downloading the new version. When this process is finished, you will have the latest available version of RealFlight G5.

CHANGES:

• Airflow calculations are correct for wings with 180 degrees of dihedral
• Electric motors cannot restart if they are mounted on a wing that has broken off
• Battery voltage draw is smoothed out for multi-engine setups
• Ducted fan prop air flow is correct
• Variation in RPM between engines in multi-engine setups is now very minor for electrics
• Aircraft Editor: Fuselage wireframe color pulses at a normal rate when selected, regardless of whether its children are editable
• When spawning an aircraft at an impromptu location (either because the airport contains no appropriate spawn control objects or because they are all too far away from the current pilot location), the aircraft is properly placed atop any objects that exist at that location instead of beneath them precisely at ground level
• Wing loading calculations are correct for wings with dihedral of more than 90 degrees. Note that this value is used for reporting purposes only (in the aircraft selection dialog and aircraft editor), not for actual physics behavior
• Controller calibration reminder message appears more frequently
• Added support for Expansion Pack 8
•Dominion 3D 90 – Flybarless: Gyros drive actual servos which control cyclic, instead of gyros feeding directly into cyclic

Source: Knife Edge Software

Advertisment

Subscribe to the post comments feeds or Leave a trackback